Serving Our Customers Since 1994 
The ER series collets are an industry standard. Our ER-16 collets will work in any spindle made to use ER-16 collets.
DeArmond Tool offers every series and size of ER collets! The list below includes every size available in the ER-16 series.
The ER Series Collets Are An Industry Standard. These are Ultra Precision Collets. Guaranteed no more than .0002" TIR.
ULTRA PRECISION! NO TOOL SLIPPAGE!
WHY BUY OURS???
This diagram plainly shows the difference between other ER collets and ours. The image on the left shows only a single point of contact between the tool surface & each jaw. Notice that our collets have over an 80% surface contact per jaw.
More Tool Contact Means Less Slippage And Higher Accuracy!
View
Shopping Cart Contents
Go To
Cart Check Out
| Nominal Diameter | Capacity |
Cost Each |
Purchase Right Here! Right Now! |
| 1/16" | .062-.043 | $21.99 | |
| 3/32" | .093-.054 | $21.99 | |
| 1/8" | .125-.086 | $21.99 | |
| 5/32" | .156-.117 | $21.99 | |
| 3/16" | .187-.148 | $21.99 | |
| 7/32" | .218-.179 | $21.99 | |
| 1/4" | .250-.211 | $21.99 | |
| 9/32" | .281-.242 | $21.99 | |
| 5/16" | .312-.273 | $21.99 | |
| 11/32" | .343-.304 | $22.99 | |
| 3/8" | .375-.336 | $22.99 | |
| 13/32 | .406-.367 | $22.99 |
View
Shopping Cart Contents
Go To
Cart Check Out